2016 Ford Focus Engine Problems

NHTSA Recall Number23V905 Recall Status recall Incomplete Ford performed an interim engine repair in 2024. Due to the unavailability of parts when the recall was initiated, it took approximately 8 months for the interim engine and repair to be completed. I received my car back in August 2024 and then a supplement to the recall was placed. After getting the car back, my check engine light came on but Ford advised that it didn't have anything to do with the engine replacement and associated parts. Then I began experiencing symptoms of a valve purge issue and received an EVAP code. I attempted to address this at the dealership during routine maintenance but it was not checked or repaired. In January 2026, my engine failed again with similar symptoms. It was towed to the same dealership where they informed me that I was out of warranty on the engine and my new issue had to do with coolant intrusion. When I checked my service records, they had noted that a coolant hose was broken and replaced during recall repairs. Additionally there is a recall for other 2016 Ford Focus coolant intrusions caused by a heater block. This leads me to believe that the repair may have been faulty. Additionally, the 23V905 recall is still open with a supplement to the original.

The transistor arm or tensioning arm for the wet belt, which drives the oil pump in the oil pan failed, leading to oil starvation to the engine, causing total catastrophic engine failure, and temporary loss of power steering, while driving, fortunately, I was moving at a slow pace in minimal traffic, however, this is a known fail point in Ford 1.0 L ecoboost 3 cyl engines, that Ford claims my vehicle does not have, and refuses to cover, regardless of the fact that it did happen, and I have pictures in mechanic testimony to prove this to be true, had I’ve been on a different road, or had more traffic, this could have to a fatality. The engine replacement would cost a estimated 4500-7500$

In the Ford 3 cylinder 1.0L Ecoboost engines there is a terrible wet belt system, there is a recall on the automatic models but nothing for the manual models, regardless of the fact that the manual models are designed far more poorly than the automatic models in the sense that the manual models have no tensioners and rely solely on the factory tension of the screws, keeping in mind that the belt is both rubber and sitting in hot oil when in use, if not a money grab, my best guess is that they hoped the wet rubber belt would simply not not stretch in good faith. 4 days after getting basic maintenance, the wet belt failed, clogging the oil pickup causing engine failure, and temporary loss of power steering, after the engine was given time to warm up, luckily the road was nearly empty, and i was driving at a slower pace. However the fact that Ford Motor Company has gone nearly a decade without dealing with the issue, and then denies having knowledge of this design flaw, is absolutely and abundantly absurd. I have all vehicle maintenance records, as well as mechanic testimony, all of which point to this incident being caused by poor engine design. In addition to the estimated cost to replace the engine is 8,500$, or about 140% the cars total value prior to the engine failure. This a NOT a minor issue, this is not even a uncommon fail point on many other manual models, this IS a major safety concern, that god forbit it, could lead to a major accident. I simply think that the Ford Motor Company should be made accountable for cheaping out for profit, at the cost of customer’s safety.

The contact owns a 2016 Ford Focus. The contact stated that while her granddaughter was driving approximately 30 MPH, the low oil pressure and check engine warning lights illuminated. The contact stated that her granddaughter heard an abnormal knocking sound coming from the engine compartment. The vehicle was driven to a dealer who was unable to diagnose the vehicle immediately. The vehicle was then taken to an independent mechanic. The vehicle was diagnosed, and it was determined that the oil pump had failed and stopped pumping oil to the engine, resulting in damage to the engine. The contact was advised that the engine and the oil pump needed to be replaced. The vehicle was not repaired. The contact had received notification of NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling); however, parts for the recall repair were not yet available to repair the vehicle. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact mailed a letter to the manufacturer about the failure, but had not yet received a response. The failure mileage was approximately 99,000.

The dual clutch for the 2016 Ford Focus SE. This model is showing an open recall on active listings but not showing up in a search via VIN. Yes the vehicle is still available for inspection. The vehicle’s transmission overheats which has left us stranded, on the interstate and regular roads, maybe times. The vehicle has broken down multiple times in the middle of the road and put us at risk of a collision. I have verified with the dealer that this is a problem with these specific cars but only after I had purchased it. The problem started right away after purchase by showing on the dash that the transmission was overheating but that same message would go back off, resulting in the dealer refusing to take a look at it under warranty. I’ve seen many other customers complain of this problem and eventually end up losing a lot of money because Ford and the dealer will not do anything to fix it. They wouldn’t even look at the vehicle to confirm that this was the problem but instead gave me the 1-800 number for Ford and then Ford told me to take it back up to the dealer who refused to even take a complaint.

The contact owns a 2016 Ford Focus. The contact stated that while accelerating from a complete stop or while driving at various speeds, the vehicle jerked, hesitated, experienced difficulty shifting into gears and stalled. The check engine warning light was illuminated. The vehicle was taken to a local dealer, where it was diagnosed that the transmission clutch actuator had failed and needed to be replaced. The vehicle was not repaired. The contact stated that the part was previously replaced under Ford Customer Satisfaction Program Number: 19N08. The manufacturer was notified of the failure. The failure mileage was approximately 130,000.

Check engine light illuminated followed by unresponsive throttle. Pulled over and the car immediately stalled. Would not restart. Came back with code P1450. There's an open recall for that exact code for 2015-2018 focus, however the 1.0L supposedly "not affected" so my vehicle is not eligible.

The contact owns a 2016 Ford Focus. The contact received notification of NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling); however, the part to do the recall repair was unavailable. The dealer was contacted. The dealer confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2016 Ford Focus. The contact stated that while driving at an undisclosed speed, the vehicle stalled. No warning lights were illuminated. The contact received notification of NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 109,420.

Notes from the Ford dealer: Oil pump belt tensioner failed causing oil pump belt to slip and starve engine for oil. Turbo was also starved of oil. Long block and turbo were replaced. This seems to be the same issue that is included in a current recall but it does not extend to all affected vehicles. Reference NHTSA# 23V905. Ford recall 23S64.

The contact owns a 2016 Ford Focus. The contact stated that the vehicle stalled while driving at various speeds and while idling. The contact was able to pull over to the side of the road. The vehicle failed to restart and had to be towed several times. The contact stated while driving 70-75 MPH, the vehicle stalled. The contact was able to pull over to the side of the road. The vehicle failed to restart and was towed to the dealer, where it was diagnosed with oil pump and fuse failure. The manufacturer was notified of the failure and related the failure to NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling). The VIN was included in the recall. The contact was charged a fee for the repair. The vehicle was not yet repaired. The failure mileage was approximately 10,000.

I was driving the speed limit at 65 MPH down a steep hill, I felt something "drop" and then the oil lamp and "Engine Fault Error" displayed. I was unable to drive faster than 30 mph. I was fortunate that no one was following close behind. I had to put on my hazards and drive half a mile more to find a safe place to pull off the road. I had to have my vehicle towed 60 miles to the nearest mechanic. I was informed that the problem was related to a known recall, but there are no parts to fix the problem and it will be months until they do. My vehicle cannot be driven and is sitting at the dealership until it can be repaired and they cannot tell me when that will be.

The contact owns a 2016 Ford Focus. The contact stated while driving 60 MPH, the contact heard a loud noise coming from the engine and heard metal parts from the engine detach from the vehicle and fall onto the road. The contact pulled over to the right side of the road and the vehicle lost braking power and the vehicle came to a complete stop. The contact exited the vehicle to inspect the vehicle and saw oil on the ground coming from the engine. The contact stated that the vehicle was towed back to the residence. The vehicle was not taken to the dealer to be diagnosed or repaired. The contact related the failure to the NHTSA Campaign Number: 23V905000 (ENGINE AND ENGINE COOLING); however, the VIN was not included in the recall. The manufacturer was made aware of the failure and informed the contact to call NHTSA Hotline to report the failure. The failure mileage was 68,000.

My car is has engine hesitation and runs rough. I have a recall call letter and the Ford dealership Ken Grody Carlsbad, Ca refused to fix the recall because it is not giving the code but I’m having issues with it.

The contact owns a 2016 Ford Focus. The contact stated that while his wife was driving on the expressway at approximately 70 MPH, the check engine warning light illuminated, and the vehicle lost motive power. The driver turned on the hazard lights. The contact stated that the failure was related to NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling). The vehicle was taken to the local dealer, where it was diagnosed that the oil pump belt had failed. The vehicle was not repaired due to parts not being available. The manufacturer was contacted, opened a case, and referred the contact to the NHTSA Hotline. The failure mileage was approximately 102,987.

The contact owns a 2016 Ford Focus. The contact stated that upon starting the vehicle, there was heavy white smoke coming from the exhaust pipe. There was no warning light illuminated. The vehicle was taken to a dealer where a diagnostic test showed that there was coolant intrusion into the engine. The contact was informed that the engine needed to be replaced. The contact was given an estimate for the repair. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to file a complaint. The vehicle was not repaired. The failure mileage was 96,000.

The contact owns a 2016 Ford Focus. The contact stated that while her husband was driving at an undisclosed speed, the vehicle inadvertently lost motive power. The driver was able to pull over to the shoulder of the roadway, where the vehicle failed to restart. No warning lights were illuminated. The vehicle was towed to the dealer, who diagnosed a failure with the oil pump tensioner assembly and oil pump drive belt, resulting in damages to the engine. The contact was informed that the engine needed to be replaced. The vehicle was repaired. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling); but the VIN was not included. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 150,000.

See attached document for complaint.

The contact owns a 2016 Ford Focus. The contact stated while driving at an undisclosed speed, there was a loud bagging sound that became worse while the brake pedal was depressed. In addition, the contact stated that white smoke was coming from the engine compartment. The vehicle was towed to the dealer where it was diagnosed with water pump and serpentine belt failure. The contact was informed that the serpentine belt and the water pump needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 136,000.

Engine is misfiring, lack of power, stallign out, barely made it home could of been a really bad accident.now engine is still running terrible, throwing multiple codes and blowing white smoke which we all know is a head gasket issue.