2015 Porsche Cayman Complaint Log

Porsche dashboard leather has strunk and separated from the main dashboard. My understanding is that in the event of an accident, this could interfere with the airbag's ability to deploy correctly. A Porsche dealer has reviewed but was unable to repair it. The next step would be to replace. I've discovered this is a very common issue with Porsche vehicles from model years similar to this one.

The contact owns a 2015 Porsche Cayman. The contact stated that the vehicle was taken to the dealer for the rear housing axle carriers repair under NHTSA Campaign Number: 21V679000 (Power Train). However, upon picking up the vehicle, the rear suspension was unstable and drifted all over the road while driving. The contact was able to drive to his residence. The vehicle was taken back to the dealer who inspected the vehicle and completed a torque adjustment however, the failure persisted. The dealer was notified but did not provide any assistance. Additionally, the contact stated that the vehicle had not experienced a failure prior to the recall repair. The contact also stated that the engine was located at the rear of the vehicle, which presented a severe potential risk to safety. The vehicle was not repaired. The manufacturer was notified of the failure and a case was opened. The contact was awaiting a call back from the manufacturer. The failure mileage was approximately 40,000.

My door panels are delaminating around where the side curtain airbags are located. It has me concerned about driving the vehicle if I was involved in an accident.

The Cayman S model with V6, 3.4L motor, commonly referenced as a 9A1 motor had been self destructing with increasing amounts of metal slivers/chips found in the drained oil, oil filter and oil filter housing. The in-warranty Porsche dealer "installed oil" was first inspected by my shop at 27,031 mi - alarmingly metal was found, PIC attached. Metal was non magnetic, appearing to be aluminium. Subsequent oil/filter inspections found the metal volume to be significantly increasing, PIC attached, putting the motor at risk of self destructing. Car was parked with only 29,509 mi in fear of having the motor blowup/lockup while driving at highway speeds. It would have the potential of stopping abruptly or locking up the rear wheels putting the car in a spin, possibly causing a crash. Risky. Without taking the motor out and disassembling, professional opinion and speculation indicates possible early main crankshaft bearing or rod bearing failure. Motor needs replaced (estimates from $25,000 to $45,000 depending on damage and whether a dealer or independent does the work.) The vehicle is currently parked and taken off the road. Too expensive to fix. Porsche North America offered no investigative or repair support because it is out of warranty. Disappointing customer support, with this being my fourth Porsche. Isolated incident or have others found a similar problem ????