2013 Ford Explorer Body & Structure Problems

After more than two years with an open recall, Ford has not been able to repair my 2013 Ford Explorer due to an inability to source the replacement parts. On Sunday, April 12th the defective A-pillar trim on the driver’s side detached while driving at highway speeds on the interstate. My Ford dealer states that there is a backorder of over 80,000 A-pillar covers. It doesn’t seem that they are very interested in addressing this recall. What recourse do I have?

The contact owns a 2013 Ford Explorer. The contact stated that while driving at an undisclosed speed, the driver's side exterior A-pillar trim detached and struck another vehicle. No warning lights were illuminated. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was taken back to the residence. Several dealers were contacted and confirmed that the part was not yet available. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 146,000.

This is a complaint regarding the handling of safety recall 20S62 (also referenced as 20S32) by Ford Motors and the dealership that performed the recall repairs, Hallada Motors. The vehicle was taken by the previous owner to Hallada 3 separate times to address the same recall related to the rear suspension toe link/ball joint issue. Documentation indicates the most recent repair occurring in 2022. This recall specifically involves components connected to the rear suspension that, if not properly addressed, can lead to corrosion and structural damage affecting the frame. Based on the history of repeated recall repairs and the current condition of the vehicle, we believe that the repair approach taken was insufficient. By the time of the third recall service in 2022, the frame should have been thoroughly inspected and potentially replaced due to corrosion risk identified in the recall guidance. The vehicle is currently being inspected and serviced at Ewald Ford. Their technicians documented significant corrosion and unusual frame damage, which they photographed and submitted to Ford corporate while requesting that the recall case be reopened. Despite this documentation, Ford has refused to reopen the recall or authorize a frame replacement. Ewald Ford technicians noticed irregularities in the documentation from Hallada Motors. 2 separate entries list the mileage as exactly 87,600 miles and exactly 95,000 miles, both ending in multiple zeros. The technicians indicated this is unusual and raised concerns whether the recall work was properly completed. The vehicle now has severe frame corrosion and structural damage and is unsafe and unusable. We are without a vehicle and have incurred financial loss. We believe the current condition is the result of improper/incomplete recall repairs. We request a look at the recall repairs performed were completed in compliance & ford's refusal to reopen is consistent with safety obligations. Ford should be held accountable.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that a technician went to the residence and diagnosed and determined that the A-pillar trim on both sides of the windshield had failed and needed to be replaced. The dealer confirmed that parts were not yet available. The vehicle was not repaired. The dealer applied duct tape to both sides of the windshield as a temporary fix. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The approximate failure mileage was 161,708.

The contact owns a 2013 Ford Explorer. While driving approximately 70 MPH, the passenger’s side A-pillar trim was blown off the vehicle by the slipstream. The dealer was not contacted because the contact had previously called the dealer and was informed that the part to repair the vehicle was not available. The VIN was included in NHTSA Campaign Number: 24V031000 (STRUCTURE). The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 145,000.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that while driving rounding a corner at a slow speed, the front passenger’s side A-pillar trim detached and separated from the vehicle. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The vehicle was not repaired. The failure mileage was approximately 150,000.

See attached document for complaint.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the recall remedy parts were not fully available. The local dealer was contacted and confirmed that the recall remedy was partially available. The dealer stated that the driver-side A-pillar trim was available, but the passenger-side A-pillar trim was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue, and a case was filed. The contact had not experienced a failure.

The contact owns a 2013 Ford Explorer. The contact stated that while driving at an undisclosed speed, the exterior A-pillar trim on both sides of the windshield began to detach. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to complete the recall repair was not yet available. The vehicle was taken to the dealer, where it was diagnosed that the A-pillar trim retention clips had failed and needed to be replaced. The vehicle was not repaired, and the dealer confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The approximate failure mileage was 180,000.

Pillar molding driver side

The contact owns a 2013 Ford Explorer. The contact stated that while the vehicle was parked, the contact noticed that the driver’s side windshield exterior A-pillar trim was significantly loose. The contact was able to temporarily secure the A-pillar trim by applying glue to the trim. The contact later received notification of NHTSA Campaign Number: 24V031000(Structure); however, the part to do the recall repair was not yet available. The vehicle was taken to an unknown dealer, but the vehicle was not diagnosed or repaired. The dealer confirmed that the recall parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 50,000.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, preventing the driver from safely operating the vehicle. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The contact stated that on a separate occasion, the driver's side A-pillar trim detached from the vehicle and was loose. The vehicle was not repaired after the most recent failure. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was unknown.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign number: 24V031000 (Structure). However, the part to do the recall repair was not yet available. The VIN tool search showed that there were no recalls associated with the VIN. The contact stated while driving at various undisclosed speeds, the passenger's side A-pillar was loose and damaged the paint on the wheel well. The local dealer was contacted and inspected the vehicle. The contact was informed that there were no issues. The dealer then orders the part to do the repair. The vehicle was not repaired. The contact stated that on a separate occasion, while driving at various undisclosed speeds, the driver's side A-pillar trim detached from the vehicle. The local dealer was contacted. The vehicle was not repaired for the most recent failure. The contact stated that the driver's side A-pillar trim was loose. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was 179,904. 

The contact owns a 2013 Ford Explorer. The contact stated that while driving at an undisclosed speed, the driver's side exterior A-pillar trim detached and flew off the vehicle. The vehicle was taken to the dealer; however, parts were not yet available to repair the vehicle. The contact stated that the vehicle was taken to the dealer several times. The contact was advised to order the parts from Amazon. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, parts were not yet available. The manufacturer was not made aware of the failure. The failure mileage was unknown.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (STRUCTURE); however, the part to do the recall repair was not yet available. The contact stated that while driving 70 MPH, the front passenger's side A-pillar trim detached from the vehicle. The trim was striking the front windshield. The contact pulled over to the side of the road and attempted to secure the trim. The local dealer was contacted. The vehicle was not repaired. The contact taped the trim after arriving at the residence. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 69,800.

The contact owns a 2013 Ford Explorer. The contact stated that while driving at an undisclosed speed, the A-pillar trim on both sides of the windshield started to detach. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The local dealer was contacted and confirmed that parts were not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The approximate failure mileage was 140,000.

Why is it taking Ford years to fix body molding for a recall. It would appear they are not going to comply with the recall and hope they wait long enough they can age out the vehicles and there won’t be any left. I don’t understand why N.H.T.S.A is night having FORD comply with the recall.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000(Structure); however, the part to do the recall repair was not yet available. The contact stated that the vehicle was taken to the dealer, where it was diagnosed that the driver's side windshield exterior A-pillar trim retention clips had failed and needed to be replaced. The vehicle was repaired; however, the contact stated that while driving at an undisclosed speed, the driver's side windshield exterior A-pillar trim started to detach. The vehicle was taken back to the dealer, where it was confirmed that the recall parts were not yet available. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure, and a case was filed. The failure mileage was approximately 104,000. VIN tool confirms parts not available.