There are 47 owner-reported steering complaints for the 2013 Mercedes-Benz C-Classin NHTSA's database. These are unverified consumer reports and may not reflect confirmed defects.
I am filing this complaint regarding a serious and recurring steering system defect involving my Mercedes-Benz vehicle and Recall Campaign No. 2017120022 (steering column defect). Mercedes-Benz corporate representatives provided conflicting information regarding whether the recall repair was completed in 2018. One representative stated it was performed; another stated no record exists. I was never notified that a recall repair had been completed. This inconsistency raises immediate concerns regarding recall documentation integrity and owner notification compliance. The identical steering column system has now failed again, resulting in a complete steering column lock and vehicle immobilization. The repair estimate exceeds 2,500. A total steering lock is a critical safety failure with clear risk implications. If the recall repair was completed, recurrence of the exact same safety-critical component failure within only a few years strongly indicates that the original recall remedy was either improperly performed, defective in itself, or fundamentally inadequate to eliminate the defect. Steering column assemblies are not routine wear items. Mercedes-trained master technicians have confirmed that such failures are rare over a vehicle’s lifetime and highly unusual shortly after replacement. Federal safety recall law requires manufacturers to fully and permanently remedy safety defects at no cost to the consumer. A failed recall remedy that results in repeat failure of the same component shifts the burden improperly onto the owner and undermines the purpose of the recall system. I respectfully request that NHTSA formally investigate whether Recall 2017120022 has resulted in recurring steering column failures following recall repairs, evaluate the sufficiency of the remedy, review Mercedes-Benz USA’s recall tracking and notification procedures, and require reimbursement if the defect represents a failed recall correction.This matter shows a serious vehicle safety concern.
My wife and the kids we're stranded for hours because of the ESL systems lock the steering wheel and did not allow the car to start or steering wheel to move. She smelled something and pulled over and turned car off. No lights, no way to charge cell phone because no power to the car at all. My family was stranded because of this seems like it's a very very serious issue with a lot of Mercedes-Benz vehicles. As a consumer Mercedes-Benz is using cheap parts which can cause people to lose their lives if the steering wheel is to lock up while driving the motor burns out inside of the ESL module
Mercedes has had an issue with the steering lock for years and continue to not fix the issue. My vehicle would not turn on at random times, and this is due to a fault with the steering lock and key. The worst part of the issue, it’s only solved by Mercedes due to security issues and costs $2000. I was locked out of my car for hours, missing a doctors appointment, and if this was during a snow storm or heavy freeze (I live in CO), this is a potential fatal flaw. I also learned they cannot fix my vehicle for months due to high demand and coming from Germany. Looking online this is a continued problem for over a decade of vehicles and this needs to be resolved either by recall, a price adjustment due to this being a Mercedes flaw, or give the capability to certified maintenance locations to do the job for a fraction of the price (I see the price of the part is marginal compared to the upcharge by the dealer.
I purchased the vehicle in 2015, and a few months ago I started having issues with the steering wheel, as well as an error message with the airbag. More recently, I am experiencing issues with my ignition switch, and after doing some research I’m seeing that many people who drive the mage and model of my vehicle are experiencing issues with their ignition switch suddenly going out. I’ve been quoted 2k to repair the issues, but I feel the Mercedes should be responsible for taking care of what seems to be a faughty ignition switch with this particular model. There was no warning, no indication that there was a problem, one day my car just wouldn’t start. I need to report this to make sure buyers are aware with issues with the C300 model for all vehicles that are a 2013 and under.
Bought a 2013 Mercedes-Benz C300 4matic on 1/16/23 with only 80k miles. Alignment was off so took it to local Mercedes dealer today on 1/24/23. They advice that the subframe was rusted and not safe to drive, they are keeping it overnight to take a closer look and evaluate. Looked into it and found this is a common issue, experienced by many all over the world. UK has rust protection so they can get it replaced for no extra cost. Why do we have to pay out of pocket? Also did buy the Carfax and showed clean with no issue found before purchasing the vehicle.
Discovered a severely "rotted/rusted" rear subframe and one of the passenger side suspension/control arm of the rear passenger side wheel is completely "detached/disconnected" from the rear subframe. During a hard brake, the car will "swing/drift" to the right and is very dangerous and prone to accident/catastrophe. Also, many other 2008-2014 C300 owners already have reported/complaints over the internet. This defect needs to be recalled by the manufacturer. The contact paid for the replacement and service repair of the rear subframe. The contact was informed by a technician that the detached rear control arm may "puncture" the gas tank because of how close it is to it. The vehicle is not recommended to be driven until the repair is made.
Rear subframe of vehicle rusted under regular use conditions and the left trailing arm mount broke off as a result. This caused vehicle braking to become extremely unstable and dangerous, even at low/medium speed. This is a known problem from this manufacturer and the Fed government should take action to force recall.
THE REAR SUBFRAME ON THE CAR IS COMPLETELY RUSTED. I GET AN OIL CHANGE AND A INSPECTION OF THE CAR DONE AT THE DEALER EACH YEAR. NOBODY MENTIONED TO ME THAT THE REAR SUBFRAME IS RUSTED AND IS ABOUT TO CRACK AND FALL APART. WAS DRIVING HOME FROM WORK WHEN I SUDDENLY HAD TO STOP AND THE WHOLE CAR SHIFTED TO THE RIGHT ALMOST CAUSING ME TO CRASH. DROVE HOME AND NOTICED A NOISE EVERY TIME I HIT THE BRAKES. THE NEXT DAY TOOK IT TO A MECHANIC AND HE SHOWED ME THAT THE SUBFRAME CRACKED AND FELL APART. I KNOW THIS IS A BIG ISSUE IN EUROPE AND THE DEALERS CHANGE IT FREE OF CHARGE SINCE IT IS ON A RECALL, BUT NOTHING IN THE USA AFTER SEVERAL COMPLAINTS FROM DRIVERS. DO SOMETHING ABOUT THIS!
The contact owns a 2013 Mercedes-Benz C300. The contact stated while driving at an undisclosed speed, the steering wheel failed to immediately respond while turning the steering wheel. After stopping the vehicle and attempting to reverse, it was discovered that the front wheels would no longer turn while turning the steering wheel in either direction. The vehicle was later towed to the residence. The cause of the failure was not yet determined. The local dealer and manufacturer were notified and the contact was informed that the VIN was not included in the NHTSA Campaign Number: 17V252000 (Steering). The contact indicated that the vehicle had experienced the failure listed in the recall. The failure mileage was 95,000.
I needed new tires and the tire dealer reported that my subframe is rotted bilaterally. He suggested I do not invest in tires until it is replaced and to notify Mercedes as there may be a recall. This defect caused instability of the frame that secures the tires. The safety risk should go without saying. Any rotted structure that supports the car and/or secures the tires is an obvious safety risk. After reading the multiple complaints posted under “structure” for this make and model, it appears that yes, this problem has been reproduced and confirmed by other owners and mechanics. I am presently picking up my car from the tire dealer and driving it directly to the Mercedes dealership…so they will be aware and able to inspect it. There were no warnings or alerts that my subframe rotted. I do not believe this is something that could be measured with a sensor to trigger an alert electronically.
Car with just 130,000 miles needs significant subframe and related parts replaced. There are countless discussion boards of similar failures across Mercedes Benz car lines. The estimated cost of repairs at the dealership exceeds $5000 just for subframe work. When braking the car veers to the left and the right end tries to swing around. Again, this is noted on multiple discussion board. MB has consistently demonstrated negligence in addressing this as service advisers state this is not uncommon and is seen often. A recall/replacement is warranted.
I noticed that my car was pulling heavy to the left when I stop and strange noise in the rear of the car, after taking the car to the mechanic he told me that the car rear subframe on my 2013 Mercedes Benz c300 was rotted, the control arm bracket completely broke off on the left side and the right side is also cracked. it appears that this is a common issue in areas of heavy road salt usage during winter months, the dealer told me that the car has a rotted rear subframe problem and the subframe could break out in months.
Sudden steering pull when braking . Mechanic found rotten left rear suspension cross member .part number 2043500141 Mechanic reports very Common issue with this model . Mercedes Benz is aware but will not repair or supply replacement parts . Note the replacement part is not available in US currently . Stuck with unsafe auto lacking support from Mercedes Benz . Some one is going to be injured / killed as the manufacturing defect shows rust failure from inside out and not detectable during routine maintenance . Hard braking pull is first indication that the defective part failed . Should this occur at highway speed the auto can flip resulting in major injury or death .
While driving normal highway speed and braking suddenly the car violently pulls to left. Same occurs when driving normal city traffic . Good afternoon I am following up on a major safety issue #11453988 concerning a 2013 C300 Mercedes. I reported this a few weeks ago as this safety defect can cause personnel injury when the defective part fails . As noted earlier during normal braking the car pulls hard to left or right . With normal highway speed driving and emergency braking the car will violently pull left or right possibility into oncoming traffic and or fixed objects . Please reply with update into this major safety defect concern . PS the part number in question has been changed from number 2043500141 with new number 2073509702. This part is not available in the US currently and has a lead time of 30 days from Germany. With the long lead time and the need to travel to work it is a major safety issue that can be avoided. Thanks George
I’ve had 2 c300 Mercedes models in the past 8 months both used and were driving fine until rain water and car washes caused electrical damage there is a water leaking issue that goes into the floorbeds of the vehicle that causes the car to malfunction
Vehicle subframe has rusted through and parts of left rear suspension components are free, and one is about to poke a hole in the fuel tank. The right side is about to do the same. Everyone’s safety is at high risk with this problem. The car abruptly pulls to the left when applying the brakes as well as causing the car to shimmy on the interstate. I took it to my mechanic who to.d me what has happened, and I had it towed to the Mercedes dealership who confirmed the problem. When you search the internet you find a highly alarming number of people who have this same problem on 2009-2014 C300 models please do something before someone gets killed.
The subframe rotted out causing the lower control arm bracket to detach from the frame. This has caused loss of control of the back left wheel and causes the car to shake and swerve when braking. This exact issue has led to recall in Canada. First noticed due to a squeaking and clunking sound. Later on the same day, I pressed the brakes on the highway and felt the described shaking/swerving. My mechanic has let me know that the car is now un-drivable due to the safety issue this causes. One of the rear subframe’s main purposes is to absorb and disperse impact. Not only have I entirely lost control of the rear left, but any crash that this could have led to could have been significantly more dangerous due to the failed subframe. As stated prior, this exact issue has led to recall in Canada and I believe that it should lead to recall in the USA as well.
Vehicle completely shut down while traveling on interstate. Ignition switch malfunction and went dead, also steering column locked causing me to lose control of steering functions.
AFTER OWNING A CPO,FOR ABOUT5 YEARS. RECENTLY THE TILT/ MECHANISM FAILED TO OPERATE. I TOOK IT TO DEALER AND WITHOUT ANY TOOLS IN HIS HANDS HE FIXED IT.ABOUT 6MONTHS IT WORKED FINE,THEN IT STOPPED.I TOOK IT BACK TO DEALER AND THE ADVISOR THAT FIXED IT IS NO LONGER WORKING THERE,NOBODY ELSE HAD EVER HEARD OF THIS METHOD?I'M NOT DREAMING HE GAVE ME HIS CARD AFTERWARDS,SO HE DOES EXIST..
ELV LOCK FAILURE ON THE IN THE STEERING COLUMN, VEHICLE DISABLED
Showing 1–20 of 47 complaints
Complaints are unverified consumer reports submitted to NHTSA. A high complaint count may reflect vehicle popularity, not defect severity. Data sourced from NHTSA public records.
Data synced from NHTSA on Apr 25, 2026