There are 4 stored owner reports matching the engine leading-label group for the 2022 Nissan Versa in our NHTSA-sourced dataset. These are unverified consumer reports and may not reflect confirmed defects.
This group counts stored reports whose component label starts with one of this site's matching prefixes, ignoring case. Each matching report counts once within the group. Components mentioned later in the label or only in the narrative are not searched. How component counts work
Loaded 4 of 4 matching reports.
Open the full vehicle complaint log (all categories)vehicle change to limp mode randomly. i need to stop turn all off wait 1 minute to restables the normal power on engine.
If the vehicle stalls when starting or depressing the clutch too fast, the vehicle will sometimes enter a low power (limp mode), where the driver can floor the accelerator and the car will barely accelerate. The absolutely max speed when this happens seems to be around 55 and it takes 30 seconds to reach this speed. Turning the car off and letting it sit for 15 seconds, and then restarting the car seems to fix the problem. This has happened to me 3 times over the past 2 years.
The contact owns a 2022 Nissan Versa. The contact stated while driving at undisclosed speeds, the vehicle started losing motive power. There was no warning light illuminated. The contact stated that during the failure, the vehicle was turned off, restarted, and operated as needed. The contact stated the failure reoccurred and the vehicle was taken to a local dealer however, the cause of the failure could not be determined. The contact stated the failure recently reoccurred, and he was able to diagnose the vehicle with an ODB scanner and retrieved DTC code: P2615 (Failure with the Camshaft Position Signal Output Circuit Low Issue). The vehicle was not repaired. The manufacturer was informed of the failure and a case was opened. The failure mileage was approximately 19,000.
This manual car puts itself into limp mode any time the engine is killed (If you drop the clutch too quickly because it is a manual transmission) while driving it. Once it is in limp mode (restricted speed and power to protect the engine) it must be pulled over and turned off for at least 15 seconds before restarting the vehicle to reset the computer and get it out of limp mode. This is a huge safety hazard in traffic, on a hill, on a freeway on ramp or many other places. This car has put itself in limp mode when it died from dropping the clutch, when it almost died while working the clutch, and when turned off and back on quickly to reset a bluetooth connection that wasn't working. A Nissan corporate regional representative, Nissan specialist and Nissan Engineer evaluated the car and said that it is a manufacturing defect - a programming issue that makes the electronic control module think that the car is not functioning properly when it dies (it happens sometimes when driving a manual transmission!) and so it puts itself into limp mode to protect the engine from a problem that doesn't exist. Nissan said the vehicle code would need reprogrammed to repair the issue. Nissan also said they have no time frame for reprogramming the code to repair the defect and to just wait--with no timeline forthcoming. This is an issue on all 2022 Manual Nissan Versa vehicles, not just this particular car as it is a programming issue. I contacted another dealership to test one of their new 2022 manual versa vehicles. They drove it and found the exact issue. I do not know if the issue was fixed on 2023 models or if it is and ongoing issue. Nissan has acknowledged the issue. Driving this car is unsafe and Nissan has said to just drive it and wait.
Complaints are unverified consumer reports submitted to NHTSA. A high complaint count may reflect vehicle popularity, not defect severity. Data sourced from NHTSA public records.
NHTSA source checks for this vehicle year
Checks are recorded separately for each dataset, not for the whole page. Dates use UTC. A missing check date does not mean no records exist.
Vehicle import recorded: Apr 28, 2026. This is the stored import date, not confirmation that every source was successfully refreshed.