There are 7 stored owner reports matching the lighting leading-label group for the 2023 Ram 2500 in our NHTSA-sourced dataset. These are unverified consumer reports and may not reflect confirmed defects.
This group counts stored reports whose component label starts with one of this site's matching prefixes, ignoring case. Each matching report counts once within the group. Components mentioned later in the label or only in the narrative are not searched. How component counts work
Loaded 7 of 7 matching reports.
Open the full vehicle complaint log (all categories)When left turn signal is activated, it causes the high beams to turn on
This complaint is a update to my complaint number 11557659. My vehicle has exhibited frequent but intermittent problems with left turn signals and headlight high beams since new. The dealership has been unable to duplicate the problems until 12/13/23 when a service technician observed the headlight flash to pass function activating the left turn signals approximately 10 times. However, when I brought the vehicle to the same dealership two days later to have Recall B2A (Malfunctioning SCCM) performed, the inspection procedures to identify malfunctioning SCCMs contained in the Stellantis guidelines failed to identify my SCCM as malfunctioning. The dealership said they couldn't replace the SCCM because the Stellantis procedures indicated that it was not malfunctioning. This was in spite of the dealership's service technician observing the vehicle failing steps 20 and 21 in the formal test procedures several times two days prior (when the vehicle wasn't undergoing a formal Recall B2A procedure). The vehicle also has a 6-month history of exhibiting problems that exactly match a malfunctioning SCCM. Based on this incident, it's very likely that the Stellantis procedures for identifying malfunctioning SCCMs under Recall B2A is not capable of identifying intermittent malfunctions that are not occuring at the exact time the procedures are being performed. This will result in many, if not the majority, of vehicles with malfunctioning SCCMs not being identified by dealerships and not being repair as required by Recall B2A.
Turning on the left turn signal causes the headlights to switch from low beams to high beams. It doesn't happen every time. I've taken it to the dealership but it doesn't happen while it's there so they don't take me seriously and, in my opinion, don't thoroughly investigate the problem.
Often times high beam lights will come on when left turn signal is applied. This can cause danger especially at night for on coming traffic if turning left.
It appears that there is a problem with the bright-lights and turn signal. When I turn on the left blinker my bright lights come on. When the turn is complete the bright lights go out. This happens during the day and night. During the day when I flash my bright lights the left turn signal comes on. Dodge forums has a lot of complaints about this with no fix. There are no warning lamps or errors showing. This happens daily and all the time.
Randomly, when powering up the vehicle, the instrument cluster emits a very bright light on the left side only. This light cannot be dimmed or turned off with the lighting controls. As a result, driving at night is dangerous with a bright light stuck on directly in front the driver. Normal functionality is for a dim accent light to show on both sides of the dash (and is controllable via a dimmer). When the problem occurs, I'm forced to drive with less than ideal visibility. Please review attached photos.
WHEN THE LEFT TURN SIGNAL IS APPLIED. HIGH BEAM LIGHTS ARE ACTIVATED. THIS WILL BLIND ON COMING TRAFFIC!
Complaints are unverified consumer reports submitted to NHTSA. A high complaint count may reflect vehicle popularity, not defect severity. Data sourced from NHTSA public records.
NHTSA source checks for this vehicle year
Checks are recorded separately for each dataset, not for the whole page. Dates use UTC. A missing check date does not mean no records exist.
Vehicle import recorded: Apr 28, 2026. This is the stored import date, not confirmation that every source was successfully refreshed.