There are 50 owner-reported engine complaints for the 2016 Ford Escapein NHTSA's database. These are unverified consumer reports and may not reflect confirmed defects.
Known coolant intrusion, blowing white smoke, blown head gasket
Description of Incident: While operating the vehicle, the Check Engine Light (CEL) illuminated. I took the vehicle to an authorized dealership, where a diagnostic scan revealed fault code P0247. The dealership confirmed that the wastegate solenoid has failed. Safety Risk: The failure of the wastegate solenoid prevents the Engine Control Unit (ECU) from properly managing turbocharger boost levels. This results in "limp mode" or a significant reduction in acceleration and engine performance. Furthermore, improper boost regulation poses a long-term risk of catastrophic engine damage, which could lead to a stall or fire while the vehicle is in motion. Additional Information: DTC Code: P0247 (Turbocharger Wastegate Solenoid B) Symptoms: Check Engine Light, diminished throttle response. Repair Status: Confirmed by dealership diagnostic and completed.
Water leaking into cylinder number 3, causing misfires and loss of coolant/ overheating
My car set a code , and the engine misfired. I took all the necessary steps, but the code reappeared. I have Car Shield, and they are saying its cracked block but refuse to replace the head gasket. My mechanic believes it's the head gasket, so a cracked block seems common in these cars, as does a bad head gasket. What should I do, and whom should I contact to fight Car Shield and Ford?
Transmission failed at 62,000 miles with no prior issues or indication to this matter.
Escape has developed water intrusion in cylinder #2 of the 2.0 ECOBOOST engine, with under 80,000 miles. continued driving of the car could cause overheating due to low coolant and potential motor seizing. check engine light has come on, with cylinder misfire but no low coolant warnings. Potential engine seizing will be a safety concern if the vehicle is in motion, causing loss of control and damage to passengers and other motorists. I have footage of the cylinder leak via inspection camera if needed.
The contact owns a 2016 Ford Escape. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently lost motive power. The contact was able to pull over to the shoulder of the roadway, where the vehicle failed to restart. The check engine warning light was illuminated. The vehicle was towed to the dealer, who determined that there was coolant intrusion in cylinder #3, resulting in damage to the engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 54,000.
According to Cleburne Ford, my 2016 Ford Escape had a coolant leak that makes the engine malfunction and they quoted me a price for a new engine installation. My safety had been impacted because now I don’t know when my engine will stop working but I need a car to get to work. An independent mechanic I took it to told me he could not find a leak or see anything wrong with it, but of course he isn’t a Ford dealership employee. I had a check engine light to which then I contacted Cleburne Ford and they were able to diagnose it and give me the bad news.
The contact owns a 2016 Ford Escape. The contact stated that while driving at an undisclosed speed, the instrument panel indicated that the engine was overheating. While driving at 35 MPH, the temperature gauge indicated that the engine was overheating. The contact pulled over to the side of the road, where the vehicle experienced complete engine failure. The vehicle was towed to a certified mechanic, who diagnosed the vehicle and determined that coolant was leaking into the engine because of a fault in the engine block. The engine needed to be replaced. The mechanic informed the contact that it was a known failure with the vehicle and referred the contact to the dealer for assistance. The vehicle was not repaired. The engine block failure was related to NHTSA Campaign Number: 26V011000 (Equipment); however, the VIN was not included. The manufacturer was informed through an online complaint of the failure; however, the contact was not able to speak with a representative. The failure mileage was approximately 110,000.
The contact owns a 2016 Ford Escape. The contact stated that while driving 40 MPH, the temperature gauge indicated that the engine was overheating before the vehicle lost motive power. The contact was able to pull over to the shoulder of the roadway, where the vehicle failure persisted. The vehicle returned to normal functionality, but the failure became a regular occurrence. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, who determined that coolant intrusion into cylinder #4 had resulted in engine damage. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 65,000.
The contact owns a 2016 Ford Escape. The contact stated that while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was taken to the dealer, who determined that coolant intrusion into various cylinders had resulted in damages to the engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 70,000.
The contact owns a 2016 Ford Escape. The contact stated while driving at an undisclosed speed, the check engine warning light illuminated and the engine overheated. The vehicle was driven to the shoulder of the road and the contact turned off the vehicle. The vehicle was restarted and driven to the residence. The contact was aware of white smoke coming from the exhaust pipe with the check engine warning light illuminated. The vehicle was taken to an independent mechanic where it was diagnosed with a cracked engine block. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. In addition, the vehicle was scheduled to be taken to the dealer for an upcoming diagnostic test. The manufacturer was made aware of the failure and a case was filed. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 105,000.
The contact owns a 2016 Ford Escape. The contact stated that while his wife was driving 25 MPH, she noticed white smoke coming from the exhaust. The driver pulled over into a gas station and called her husband to inform him of the failure and drove the vehicle to the dealer. The vehicle was taken a dealer and was inspected, and the technician became aware of a leak; however, the technician was unable to determine the location of the leak. The vehicle was then taken to another dealer where it was diagnosed with coolant leaking into cylinder #1. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The contact related the failure to Technical Service Bulletin: 22-2229 (Eco boost 2.0L Engine Failures); however, the VIN was not included. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure and opened a case. The failure mileage was 132,000.
Coolant leak into cylinder head. Upon start up a cloud of white smoke came from the exhaust.
Coolant intrusion into the ecosystem turbo. It is a known issue, but not disclosed and now the engine has to be replaced at a cost of what the vehicle is worth?!
The contact owns a 2016 Ford Escape. The contact stated while driving approximately 35 MPH, the engine warning light illuminated. The vehicle was taken to the local dealer and was diagnosed with coolant intrusion into the engine. The dealer recommended that the engine be replaced. The manufacturer was contacted and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 40,000.
The contact owns a 2016 Ford Escape. The contact stated while driving at an undisclosed speed, the temperature gauge indicated that the engine was overheating, prompting the contact to discontinue driving the vehicle. No warning lights were illuminated. The vehicle was taken to the dealer, who determined that there was coolant intrusion into several cylinders, resulting in damage to the engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure but provided no assistance. The failure mileage was 88,000.
I bought the 2016 Ford Escape and 2 weeks after the purchase the check engine light came on. I took it to Auto Zone and they said it was a spark plug. I had a full tune up done 2 days after the purchase so I called the garage and they replaced the spark plug. The light came back on a few hours later so I then took it to the Ford dealership and paid over 500.00 to have it fixed, along with the camera glitching. The day I picked up my car the check engine light came back on so I immediately took it back. They re-evaluated it and said that it is a manufacturing defect and that there is nothing they can do unless I want to replace the engine and that there was no guarantee that the new engine would not have the same issue. Apparently there are holes all throughout the engine and the antifreeze is mixing with the oil. I only drove it a total of 6 months before it completely died. Because I bought it from a buy here pay here lot he wouldn’t take it back even though I only had it 2weeks. My extended warranty would not cover the engine because it’s a manufacturing defect and I was stuck with a car note plus full coverage insurance on a car I could not drive. Ford never reimbursed me for the camera glitch that I paid for that is still not fixed and when I called Ford to see if there was anything that they could do to help me they said unfortunately they are in a lawsuit in California over the same issues I was having so no help is available at the time. The craziest part is the clerk at the Ford dealership told me to hurry up and trade it in at a different dealership that’s not Ford owned because I have a “Ford Pass” all Ford dealership can see the history of the car. And let it be someone else’s problem.
Head gasket failure, coolant is leaking into the engine causing combustion and potential fire
Engine 1.6l needs replaced with less than 100k miles because of coolant leaking into cylinder causing misfire, only fix is a new engine for 8k! Serviced every 3000k miles by the local ford dealer
Showing 1–20 of 50 complaints
Complaints are unverified consumer reports submitted to NHTSA. A high complaint count may reflect vehicle popularity, not defect severity. Data sourced from NHTSA public records.
Data synced from NHTSA on Apr 26, 2026