2019 Toyota Tacoma Brakes Problems

I have the exact same issues as the big recall done with the Toyotas for the brake master cylinder. My Tacoma is leaking brake fluid from the inside of the cabin! I contacted Toyota showed the pictures and evidence, I have the exact same issue as all the other trucks with the recall, Toyota refused to help me fix my truck, even tho everything is exactly the same. They argued that because the date my truck was assembled is why they wouldn’t help. They cannot track which parts are used for which dates! It’s not fair, they know this is a huge problem which is why they had a large recall for the Tacomas. My truck barely had 55k miles on it, I shouldn’t be having brake master cylinder issues at this mileage, it’s a 2019, it’s way too new for these problems! This should be covered under the recall. It’s a faulty seal from the inside of the brake master cylinder. Toyota refuses to help or fix it. This is a severe safety issue and concern, I could have crashed or killed myself. My warranty just expired in December. This master cylinder is only made by Toyota and it’s a $1600 part. This should all be covered by Toyota under the recall for safety! This is now going to cost me around $2,000 to fix out of my pocket, all for my own safety. My truck sat for 2-3 weeks waiting for Toyota all for them to deny helping me.

BRAKE FLUID IS LEAKING IN CAB OF VEHICLE BY PEDAL C/A ~|~CONFIRMED BRAKE FLUID LEAK SEEPING FROM BRAKE MASTER, LEAKING FROM ACTUATOR TO BRAKE PEADAL AND DRIPS OF FLUID FOUND ON FLOOR OF VEHICLE.

Brakes pedal inside car was dripping brake fluid and there was a loss of power when breaking. The vehicle was taken to a Toyota dealership and they diagnosed the problem as a failure of the brake master cylinder (part # 47050-04180). There was no warning lamp or messages of the problem prior to brakes having loss of power when breaking and fluid dripping from brake pedal inside of vehicle.

Brake fluid leaking into the cab floor of 2019 Toyota Tacoma. VIN not listed on NHTSA list. Toyota refuses to believe this is the same issue as recall, as per Yemi at 10:48AM on Sept 18, 2024 Toyota Corporate call 1-800-331-4331. Brake master cylinder diagnosed by independent, non-bias mechanic as: "Diagnosed brake fluid seeping through dust seal inside cabin running down shaft connecting the pedal to assembly, fluid is of consistency of the brake fluid required by system, fluid level is low at this time, if pedal is pumped 5 times and held down there is visible drip from the rod to pedal connection, needs master Cyl. assembly and exhibits same issues and description of fault as set forth in the recall notice. Customer advised to seek manufacturer assistance." Previous examination by local Toyota dealer was fluid leaking from steering column.

Approximately 100 feet from the vehicle, I rear end of the car in front of me. when I hit the brake pedal it didn’t seem like it stopped the vehicle I ran into another car and totaled the Toyota Tacoma. Conditions for dry and cloudy and road construction nearby.

Leaking of brake fluid from brake master cylinder into driver footwell.

Break Master Cylinder leaking.

Brake fluid leaking into driver-side floorboard. Due to leak in brake master cylinder seal. Recalls have been issued for same year and model, but my truck is not included. I assume mine has a different manufacturing date. Yet my truck has the same problem as those with the recall.

When driving the vehicle to work - the brakes failed and the emergency brake had to be used to bring the vehicle to a complete stop. The vehicle had to be towed to a Toyota dealership where it was diagnosed that the master brake cylinder needs to be replaced.

I was at a stop light and when the light turn green I started driving forward and the ABS/ Brake lights on instrument cluster came on with repeated blinking. I slowed off the gas to apply the brakes. Brake pedal went to the floor with no brakes or slowing down at all. Luckily no one was in front of me and I had to pull the emergency brake. It was the only brakes I had at all. Once vehicle was towed to the nearest Toyota Dealer I had them diagnose the problem. Right rear wheel had leaked out fluid due to the rear brake cylinder failing. Upon repair of all brake pads, rotors, brake shoes, brake drums, both rear brake cylinders the problem was still an issue. Costly amounts of money already being spent to find out another failure with the Brake Master Cylinder/ Module. That part alone is also very expensive. Research has shown that the 2018 and 2019 Toyota Tacoma’s did have history of faulty brakes in turn possibly causing an accident. For my case on the road I was lucky. I can’t understand a loyal customer of years with Toyota that the company refuses any sort of aid and assistance in the matter. Why did the recalls end? Especially if this affected not just the 2018 model but the 2019 model like my Tacoma as well. For such low miles and no abuse this vehicle has faced other failures not only with the brakes alone. Vehicle is still with the Dealer at this time. Requesting some assistance in the matter please. Thank you!

Coming back home at 15:00 on 12 /22/22 it was light snow day on two lane county road my wife was following back for are mother in laws , West snoqualmie valley road carnation Washington , speed 30 miles per hours I was coming into a turn that cautions 35 miles or less and the. My dash comes up a yellow triangle with a exclamation and my brake pedal disappears out from under my feet and the brakes lock up and slide of the side of the road into the grass , put the truck into park then I try to put engage the brake pedal up towards me with my foot and the motor stalls /cuts out , I push the start button system comes back on and out into four wheel drive to get out of the grass/ cow field and the check engine stays yellow . I take it Toyota and they tell me everything is fine and it was just a traction issue with the program of the truck

The contact owns a 2019 Toyota Tacoma. The contact stated while his wife was driving 30 MPH and depressing the brake pedal, the vehicle failed to immediately stop. The driver stated that the oil service warning light was illuminated. The driver pumped the brake pedal forcefully to the floor to stop the vehicle. The driver was able to continue driving to her destination. The contact called the local dealer and made them aware of the failure. The vehicle was not diagnosed or repaired. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 18V888000 (Services Brakes, Hydraulic) however, the VIN was not included. The manufacturer had been informed of the failure. The failure mileage was approximately 64,000.

Brake fluid leaking from master cylinder through the firewall back inside the cab and down the brake pedal.Appears it has a Defective seal in the master cylinder.Brake pedal seems harder than normal.

My car while driving every so often miles will have the abs light go on with the traction control light and the amb symbol going off. When plugged into device at auto zone code C1422 stating the master cylinder pressure sensor zero point high. I’ve tried replacing the break light switch which is a common repair for people with that problem I’ve checked all harness and wiring all is intact and undamaged/ no water damage. When I look up my vin number in kellybluebooks website a recall appears for a brake master cylinder recall for improper machining of the brake master master cylinder. Which will cause internal damage of one of the seals, affecting brake performance. It affected 44121 of vehicles of my year. But when looked up in this website and Toyota no recalls appear which is strange. The defect it has when the abs light and etc. lights go off is it will force the car to stop moving by locking the brake system and smoking out the calipers till brought to 0mph which is very dangerous when operating in the freeway as cars behind my aren’t expecting a sudden stop. The repair is to replace the whole master cylinder. Which Toyota would want me to pay but it should be a defect from a recall.

IN A MATTER OF MINUTES, THE BRAKES WERE FINE AND THEN THEY WEREN'T. THERE WAS NO NOTICE GIVEN. PUSHED ON THE BRAKES, THE PEDAL WENT TO THE FLOOR AND DID NOT STOP OR SLOW THE VEHICLE DOWN. PUMPED THE BRAKES AND WAS ABLE TO SAFELY DECELERATE, BUT NOT BEFORE ALMOST CRASHING INTO THE CAR IN FRONT OF ME. AN INDEPENDENT BRAKE SHOP HAS INDICATED THE MASTER CYLINDER IS LEAKING INTERNALLY. THERE IS A SAFETY RECALL (18V-888) FOR PRODUCTION DATES OF 30 DAYS BEFORE THIS VEHICLE WAS PRODUCED. SEEMS TO ME THAT THIS VEHICLE EXHIBITS THE IDENTICAL BEHAVIOR IN THE RECALL THAT APPLIES TO "NOT" THIS ONE. AT LEAST AT THE TIME OF THIS WRITING.

Brake pedal went to floor as I tried to stop truck from hitting a VW that rear ended a truck in front of them. I can still press brake pedal to floor taking just a few seconds to do so. I have forward this fact to my insurance adjuster, along with the dash camera footage of the accident.

MULTIPLE OCCURANCES - 2019 TACOMA 42XXX MILES AND ON THE 3RD ISSUE OF WARPING FRONT ROTORS. VEHICLE IS HIGHWAY DRIVEN PRIMARILY AND ROTORS WARP AND CAUSE SHAKING WHILE BRAKING AT OR AROUND 3000 MILES AFTER HAVING THEM CUT OR REPLACED. SHAKING IS VIOLENT WHEN SLOWING FROM 65-70MPH AND LIGHTLY PRESENT DURRING CITY DRIVING. THIS ISSUE WAS ALSO A PROBLEM ON MY PREVIOUS 2019 TACOMA, MY 2018 TOYOTA CHR, AND MY 2014 TOYOTA COROLLA LEADING ME TO BELIEVE THIS IS NOT A MODEL SPECIFIC ISSUE. ON PAST VEHICLE THE CONCERN WAS RESOLVED BY SWITCHING TO A NON OEM ROTOR. EVERY TOYOTA I HAVE DRIVEN THAT WAS 20110 OR NEWER ALSO HAS A HEAVY FRONT BIAS TO ITS BRAKE PRESSURE DISTRIBUTION WHICH IS MORE THANK LIKELY A KEY COMPONENT TO THE CAUSE OF THIS ONGOING CONCERN.

VEHICLE STOPS AS EXPECTED WITH NORMAL BRAKING ACTION. WHILE SITTING STOPPED WITH ENGINE RUNNING APPLYING PRESSURE TO BRAKE PEDAL RESULTS IN BRAKE PEDAL GOING ALMOST TO THE FLOOR ~ SEEMS LIKE THE BRAKE PRESSURE IS "BLEEDING OFF" FROM THE SYSTEM. IN THIS SITUATION - BRAKE PEDAL ALMOST TO FLOOR - THE VEHICLE DOES NOT MOVE. TOOK VEHICLE TO DEALER AND THEY SAID THIS WAS "NORMAL" ~ NEVER HAD THIS SITUATION IN ANY OTHER VEHICLE I HAVE OWNED OR DRIVEN. IN ALL OTHER VEHICLES I HAVE DRIVEN WHEN THE BRAKE IS PRESSED, SOPPING THE VEHICLE, AND WITH CONSTANT PRESSURE ON THE BRAKE PEDAL, THE PEDAL DOES NOT SLOWLY GO DOWN TO ALMOST THE FLOOR.

MY 2019 TACOMA 4X4 DBL CAB SR5 HAS 22000 MILES ON IT AND HAS A HISTORY OF THE BRAKES PULSING. THE DEALER HAS REPLACED BOTH FRONT AND REAR BRAKES AT 5K AND 11K MILES, AND NOW AGAIN AT 22K MILES. AT EACH SERVICE APPOINTMENT I COMPLAINED THAT THE BRAKES PULSE BADLY, AND THEY CONFIRM THAT THE ROTORS AND BACK DRUMS ARE WARPED. SO THEY REPLACE THE ROTORS & DRUMS, AND THE PROBLEM IS RELIEVED FOR A TIME, BUT THE PULSING COMES BACK WITHIN A FEW THOUSAND MILES. I KEEP TELLING THE SERVICE PEOPLE THAT THERE MUST BE A DIFFERENT PROBLEM CAUSING THE BRAKES TO WARP BUT THEY JUST SHRUG IT OFF.

WHEN APPLYING THE POWER BRAKES AT A STOP THE PEDAL AFTER A FEW SECONDS STARTS TO FADE TO THE FLOOR IF RELEASED AND REAPPLIED THEY COME BACK UP TO STOP POSITION AND WILL FADE AGAIN. WHEN BACKING UP AND BRAKES ARE APPLIED AND BACKING SLOWLY TO HOUSE GARAGE THE BRAKE STARTS TO FADE TO THE FLOOR AND HAS TO BE REAPPLIED TO STOP THE TRUCK. YESTERDAY IN A SHOPPING MALL I HAD TO GO AROUND A PARKED CAR WITH ANOTHER CAR HEADED IN MY DIRECTION HAD TO APPLY BRAKES AND SLOWLY MOVE PAST THE PARKED CAR THE PEDAL WENT SO FAR DOWN MY FOOT HIT THE ACCELERATOR AND HAD TO TAKE MY FOOT OFF THE BRAKE PEDAL AND REAPPLY THE BRAKES. HAD TRUCK BACK TO TOYOTA DEALER TWICE AND THEY INSIST THERE IS NO PROBLEM WITH THE TRUCK. IF YOU HAVE EVER DRIVEN AN OLDER CAR WHERE THE MASTER CYLINDER FAILS THAT IS EXACTLY WHAT IT FEELS LIKE, HAVING THAT EXPERIENCE ONCE IN MY DRIVING CAREER OF OVER 60 YEARS/ THE TRUCK TO ME IS NOT A SAFE VEHICLE TO DRIVE AND AM CONCERNED FOR MYSELF AND MY WIFES SAFETY.CALLED CUSTOMER SERVICE 1-800 NUMBER AND WAS TOLD NOTHING THEY CAN DO IF SERVICE DEPT SAID NO PROBLEM WITH THE TRUCK, LOOKING FOR SOME SOLUTION I SEE OTHERS HAVE POSTED THE SAME PROBLEM ON YOUR WEB SITE. THANK YOU .