2024 Ford Maverick Electrical System Problems

I am reporting a recurring safety-critical failure. On two separate occasions, the vehicle has experienced a total electrical and mechanical shutdown while in operation. During these events, the 12V power system fails completely, turning off all instrumentation and, most critically, the electronic power brake assist. This results in a 'hard pedal' condition where the vehicle is nearly impossible to stop without extreme physical force. The first instance occurred at road speeds, forcing an emergency maneuver into a turning lane to avoid traffic. The second instance occurred while reversing, causing the vehicle to lose all braking and propulsion and roll into a busy road resulting in a near-miss collision. The vehicle is currently unsafe to drive as the shutdowns are intermittent and occur without warning.

Vehicle keeps going into "Battery Saver Mode" and having 12-volt battery not maintaining charge. When the battery gets low, the vehicle beings having various electrical system glitches and drivability issues. This is a well-known issue with Ford Maverick Hybrid trucks and Ford is not fixing the problem. Ford changed the 12 volt battery in the 2025 and 2026 Maverick Hybrids to an AGM design due to this issue.

AFTER ABOUT 10 MONTHS AFTER BUYING THIS HYBRID TRUCK, THE 12V BATTERY WAS NOT HOLDING A CHARGE. I STARTED TO RECEIVE EMAILS ON MY PHONE FROM THE TRUCK STATING IT WAS GOING INTO "SLEEP MODE" AND TO DRIVE THE TRUCK TO MAINTAIN THE CHARGE. I DID THIS FOR 45 MINUTES AT 60 MPH. IT APEARED TO CHARGE BUT DID NOT LAST MORE THAN A COUPLE OF DAYS. I DROVE THE TRUCK FROM SOUTH CAROLINA TO OHIO. I WAS IN OHIO FOR 10 DAYS AND DROVE ABOUT 750 MILES AND THEN BACK TO SC WITH NO PROBLEMS. HOWEVER, AFTER 4 WEEKS, I STARTED GETTING THE SAME EMAILS. I AGAIN DROVE ABOUT 45 MINUTES AT 60 MPH. THIS TIME IT DID NOT CHARGE. I RESEARCHED THIS PROBLEM ON THE INTERNET, AND FOUND MANY OWNERS OF THIS TRUCK WERE EXPERIENCING THE SAME PROBLEM. I TOOK THIS TRUCK TO A LOCAL FORD DEALER AND EXPLAINED THE PROBLEM OF THE BATTERY WAS NOT HOLDING A CHARGE. HE STATED THAT IT WAS A BAD BATTERY AND REPLACED IT (01-19-2026). HOWEVER, THE WORK ORDER STATED THAT THE TRUCK WAS "SLOW TO START" - - - NOT THAT THE BATTERY WAS NOT CHARGING. I DID NOT QUESTION HIM, BECAUSE I WAS HAPPY TO GET A NEW BATTERY TO RESOLVE THE PROBLEM. LATER, I BECAME CONCERNED THAT THE PROBLEM MAY NOT ACTULLY BE FIXED. MY CONCERNS: 1) WHY THE WORK ORDER DID NOT EXPRESS THE PROBLEM; 2) IS THIS GOING TO HAPPEN AGAIN AND LEAVE ME STRANDED; 3) WHY ARE SO MANY OTHER OWNERS HAVING THE SAME PROBLEM.

BATTERY FOR VEHICLE WILL NOT HOLD A CHARGE EVEN THOUGH ONE YEAR OLD. EVEN IF VEHICLE IS DRIVEN THE DAY BEFORE THE BATTERY GOES DEAD DEALERSHIP ADVISES VEHICLE MUST BE DRIVEN DAILY TO MAINTAIN BATTERY DUE TO ELECTRONICS IN HYBRID CONSTANTLY RUNNING. NOTE: VEHICLE GARAGED IN CT. WEATHER ON AVERAGE WAS IN LOW 30 DEGREES MUST USE A TRICKLE CHARGER TO MAINTAIN BATTERY OR A JUMPSTART IS REQUIRED DAILY

Reverse image is freezing, even after the truck’s recall was addressed by a local Ford dealership. This is a safety issue and could potentially cost a life if someone is backing up and the reverse image freezes.

My reverse camera was having intermittent issues consistent with the recall notice where it would freeze and not show a true representation of what was behind the vehicle while in reverse. I had the recall repair work done by my local dealer for the reverse camera and the problem has not been fully resolved. The framerate on the reverse camera is still inconsistent, and the problem has not been fixed entirely. It does not give me confidence that the screen will not freeze again in the future. It appears that the software update put out by Ford does not solve the problem, in my case it made the problem appear differently, but it did not resolve the safety issue. Every time I reverse in my truck, it puts my and others safety in jeopardy. If the reverse camera ever freezes, there is no indication that it has done so. This is problematic if I were in reverse while not moving, and the camera froze with a clear path behind me. If a pedestrian, cyclist, or other vehicle moved into the path of my vehicle while the screen remained frozen and I began to reverse, it is likely that I could back into them without any indication they were there. This is worse than having no reverse camera, as it gives a false sense of security that it is safe to proceed when it may not actually be. It appears that Ford has attempted to solve a hardware issue with a software patch that is insufficient to fix the issue with the freezing reverse camera image, though the true cause is unknown to me. It is unacceptable that after having the problem 'fixed' by an approved dealer the reverse camera is still not acting properly.

On [XXX] brought Maverick 24 2.0L gas AWD on Electronic Control Unit ( ECU) to Ford Dealer#3 PJ Ford. Was advised Hybrid trucks have ECU on inside bulkhead rear cab wall behind flip down seat. However on later 2.0 L options gas are mounted behind driver side front bumper near and behind front driver side plastic/ fabric wheel well parallel to shot axel ( CVJ) approximately 12 high from ground. Upon first truck was engine started to stall due to water spay entering uncovered rear of plastic axel. Having other Broncos and Range Rover Sport filed complaint with FMC today after requesting to have ECU relocated to where Hybrid are mounted : PJ FORD service mgr. refused and FMC stated bring to another Ford dealer Bayville Ford 14 miles to south on Thursday 4/10/25 for second warrantee claim. I am afraid that in heavy rain with road flooding over 12" the engine will die and cause a rear end collision. I have waited 90 days on recall 24S59 real view camera freezing now have to get out to measure one foot of road water or waves from other trucks assembled properly. I will keep Maverick for sunny days until FMC correct " mis Assembly " of ECU in Mexico Assembly factory. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Upon exiting my garage I always stop to close the door. My driveway has incline. I begin to roll back, hit the breaks several times with no engagement, begin pumping the brake pedal several times, no response. Continued to roll in reverse going across the street and hit neighbor's park car in their driveway. Police Officer noted that brake pedal was very low upon applying brakes and a hiss sound of like a vacuum or pressure lost. Reported a claim to insurance company. I never observed any indication of faults. Had truck toed to Greiner Ford to be inspected and or repaired. They said they could not find anything wrong with brake system or electronics. Since the incident I have reviewed by Ring camera video of that day and noticed that the DRL lights were flashing like a turn signal light which are not supposed to do. Truck is presently at Greiner Ford Collision Center for repair of damage to drive side rearend. I will have Greiner reinspect once collision damage is repaired and advise them of the flashing DRL's Other problems encountered prior to this incident: 1. Several times with adaptative cruise on and lane departure on there has been several notifications of cancelations were noted. 2. Several times horn has sounded when opening door with truck turned off. 3. Pre collision notification without anything in front of truck. I will also note that after receipt of new vehicle, approximately 1 to 2 months the truck was updated with new software.