2024 Toyota Tundra Powertrain & Transmission Problems

2024 Toyota Tundra 4X4 SR5 CrewMax 6.5, VIN: [XXX] , 28,500 miles. Three distinct, worsening vibration issues affecting separate systems: 1 — Powertrain/Driveline: Significant vibration on initial acceleration, under tow load, and on inclines. Suspected driveshaft carrier bearing, U-joint, or engine main bearing failure. Recall 25V-767 (V35A engine bearing debris, 2022–2024 Tundra) — VIN recall status to be confirmed at [XXX] . Component available for inspection. 2 — Highway vibration 40–70 mph: Constant speed-dependent vibration in steering wheel, seat, and floor. Worsening and expanding in speed range over time. Impairs steering feedback — direct safety hazard at highway speed. Suspected wheel bearing or hub failure. No warning lamps present at any time. 3 — Braking: Violent vibration during heavy deceleration, downhill braking, and rapid stops. Severely impairs controlled stopping and risks loss of vehicle control. Consistent with rotor degradation per Toyota TSB (Nov. 2025, 2022–2026 Tundra). Repair history: OEM tires replaced at 20,000 miles — abnormal camber-induced outside shoulder wear. Toyota issued a Limited Service Campaign for this identical defect on 2022–2023 models but explicitly excluded 2024. All 4 tires replaced twice. Multiple alignments, balancings, and rotations performed at L&S Toyota, Beckley, WV (3+ dealer visits) and an independent tire chain (3+ visits). No resolution. Defect is mechanical, not tire-related. No DTCs or warning lights at any visit. Safety risk: Braking vibration risks loss of control on downgrades and emergency stops. Highway vibration impairs steering feedback over extended driving. Towing vibration creates trailer instability on public roads. Requesting NHTSA investigate and include 2024 Tundra in the existing Limited Service Campaign covering this known defect on prior model years. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

approaching a round about at a slow rate of speed, prior to entering I noticed there was time to safely enter the round about ahead of a car also entering the roundabout from another direction. I pushed the accelerator pedal to about 30% at the time I choose to enter the traffic circle and attempted to enter. The truck did nothing in response except keep rolling forward due to the momentum I already had while approaching the round about / traffic circle. After about 2 seconds, I pressed the pedal to about 70%. This still did nothing for about another 1 second, before the truck accelerated as if I had pressed the pedal to 70% from a stop. fast acceleration into the round about which caused a narrow miss between me and the original car mentioned that was also entering the traffic circle.

Very commonly when the truck is “cold” after sitting overnight, the truck fails to accelerate from a stop while pushing the accelerator pedal down gradually (such as when leaving a stop sign at an intersection. This lack of acceleration makes me feel a loss of control as I cannot get the truck to accelerate. For example, driving out of my neighborhood into oncoming road traffic I feel as if the truck doesn’t sense my pedal input. The truck just “floats” for at least a few seconds before the pedal reaches a point where the truck recognizes the input and activates acceleration. I can see this situation causing a safety hazard such as when trying to gain speed from a stop. The dealerships says it’s a non-issue and normal for a turbo-charged engine. I have owned cars with turbo-charged engines and have never experienced this bad of lag before. I don’t feel this is normal. My truck currently has no engine issues and is maintained routinely.

I live in a city with many roundabouts for intersections. These do not require a full stop, rather a yield and go. I often encounter throttle lag when I roll into the roundabout and need to accelerate to fit a gap in traffic. This lag results in the inability of a continuous flow of traffic because my vehicle simply does not respond to the accelerator.

My vehicle is equipped with the same V35A-FTS 3.4L Twin-Turbo V6 engine and #1 main bearing assembly that is currently under federal recall for catastrophic engine failure (Recalls 24V-381 and 25V-767). Despite the shared mechanical defect of machining debris and bearing tolerances, Toyota has excluded the i-FORCE MAX Hybrid models based on the assumption that the electric motor provides sufficient 'limp home' capability. I believe this is a critical safety oversight, as a sudden internal combustion engine seizure at highway speeds creates an unpredictable loss of motive power that a small hybrid battery cannot safely manage in high-speed traffic. I am filing this to urge the NHTSA to expand the recall scope to include hybrids, as the primary power source is fundamentally defective and prone to stalling without warning

The brakes squeal when reversing and sometimes when you’re driving forward coming to a stop. It has done this since the day I picked it up at the dealership. The dealership says there’s no remedy for it yet. The next thing is the front fog lights also draw moisture just like the rear reverse lights. Dealership says there’s no remedy for it or fix for it. I’ve had to have the radiator replaced twice in this vehicle and it only has 44,000 miles on it. The dealership says it’s a factory defect. Not sure if that’s true or not. It was not covered under warranty so I had to spend $200 to use my extended warranty. I do not think that is right it should’ve been covered under the manufacturers warning, especially if it was a manufacturer defect. The last but most important thing is the lag when you give it gas. This happens from a complete stop or also like if you’re trying to accelerate to get on the highway you can press it nice and slow and it won’t takeoff or you can mash on it all the way to the floor and it still takes a few seconds and then kind of vibrates and pops like it’s trying to skip gears before it takes off and goes. Dealership also says there’s nothing wrong with it. I believe it is a factory defect or some kind of wiring problem. The reason why I think it is a computer or wiring issue is that if you put the vehicle in sport mode, it will not do it coming from a complete stop. It does do it when you’re getting on the highway even in sport mode. I am on a few Facebook forums and I see this problem where people report this problem all the time and ask how to fix it. I would like information on how to get Toyota to buy my vehicle back. These trucks have had so many issues with engine recalls, engine replacement, and other issues that are an actual safety concern and I do not feel like it is a safe vehicle to be traveling with my family. Thanks, [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I am an automotive engineer. I have been involved with vehicle development programs in the disabled vehicle conversion community for over two decades and have numerous patents in that space. I have been involved with vehicle testing and calibration as well. My vehicle demonstrates a SIGNIFICANT HESITATION when the accelerator is pressed that is not consistent. I live in a roundabout dense location where timing an entry into a roundabout is easy using a normal vehicle. The 1 to 2 second hesitation where there is throttle input and no action at all from the vehicle (engine does not rev, no motive power observed) is very dangerous. I took this up with Toyota and my vehicle was checked out and "learning transmission" memory was wiped clean with me being the only driver was the remedy. The issue got better for a short time but is back and this morning I pulled out thinking there was plenty of time in front of a bus a good distance away and the lack of motive power for a full second or two resulted in a near miss. This vehicle has about 20,000 miles and was purchased by me new. There are NO WARNING LAMPS, and no DTCs thrown when this happens. I have seen several videos where people cite the same experience and a website where there is a class action lawsuit in place regarding this issue. This is completely separate from the engine recall issue. I feel as though this issue is a significant safety risk.

I was stopped and went to pull out of the gas station. With my foot on the throttle I pull out. And it would not accelerate. I had to pump the gas pedal I almost got hit by oncoming traffic due to the lack of acceleration this has happened multiple times Very dangerous

Like most other third gen tundra owners, I experience a significant delay at random between pressing the throttle and actual vehicle movement. Often in unsafe situations, such as in traffic or at intersections, the vehicle will not move for 1-5 seconds upon pressing the throttle/pedal. When it finally does move, it will jump forward, startling passengers. This is a clear safety concern that occurs across Tundra 3rd gen models that Toyota has not addressed. I have personally been in several situations where this delay carried a risk of an accident. This has occurred since the truck is new. It now has 30k miles and is meticulously maintained.

Transmission does not shift into gear after accelerating from a brief or rolling stop.

I have had an issue several times which nearly resulted in a traffic accident. The truck has a sudden loss of acceleration where the gas pedal is completely dead. It last a few seconds and then goes back to normal. This has nearly caused several accidents where I could not properly accelerate while traffic was heading in my direction. After talking with other Tundra owners, I am not the only one with this issue. This needs immediate attention. If it is not fixed as soon as possible, I fear that someone will get seriously injured or killed. Please take this matter seriously. I suspect it may have something to do with the pre collision sensor system on the truck. It seems that it happens when there is a slight grade or dip in the road. Perhaps the sensors are at a lower angle due to the dip, making it think there is an object it will hit. The Toyota service centers don’t appear to know why this is happening and cannot reproduce the issue in a short visit.

Extreme lag response from stop on numerous occasions causing vehicle to not move for well over 1-2 seconds. Seems to happen mostly within 5 mins of start up. Had to stop slightly out in intersections several times due to this lag not allowing me to proceed safely. It doesn’t sputter at all, it just doesn’t move

Throttle hesitation. Seems to be a widely experienced issue with many third gen tundra owners. Press the gas, expecting the truck to drive, but it just lags a few seconds, then will finally engage and begin driving. Has put me in some close calls in traffic.

Throttle lag/hesitation. When pressing the gas pedal from a stop nothing happens for more than 5 seconds or longer. There is significant lag before the vehicle will accelerate.

Vehicle lag / hesitation after pressing the gas pedal.

While driving down the highway at ~70 mph, the truck's powertrain suddenly shut off. The electronics still worked, but the RPMs dropped to zero. I was forced to pull off to the side of the road, where I tried to turn off and turn back on. The truck kept on turning off and on by itself electronically, but the engine and transmission wouldn't engage for roughly 10 minutes. I was eventually able to start the truck and limp home, but the engine was knocking afterward. Completely shutting down while driving down the highway at cruising speeds is insanely unsafe.

Throttle lag/hesitation when making a right hand turn after a stop. Truck was moving after taking my foot off the break to advance my vehicle to get a clear line of sight due to cars parked on the roadway. Once line of sight was clear there was a lag/hesitation after stepping on the accelerator

My 2024 Toyota Tundra Platinum Non/Hybrid regularly stalls when trying to accelerate from a stop. This happens every day. When accelerating from a stop, the truck takes several seconds to move the truck to the point of almost being hit by oncoming traffic that I should have plenty of time to turn in front of. This is a very common problem among the Toyota Tundra community. I’ve brought this up to my dealer several times. They document it and call it normal operation.

I am experiencing an ongoing issue since the truck was new: the engine hesitates upon acceleration at any speed. When stopped this lag in throttle response makes it difficult to navigate in heavy or unpredictable traffic as the vehicle does not response to the pedal instantly and making intentional sudden speed changes is all but impossible to do safely. Depressing the pedal heavy to try and hasten the response makes the truck surge into hard and fast acceleration, worsening the issue. I have discussed this with the dealer and they said this is “normal” for this truck, and I have heard the same from numerous other 3rd generation Tundra owners. This is a safety issue because I don’t have adequate control of the vehicle’s dynamics as the computer is overriding my control of the acceleration, presumably to improve fuel economy. Ultimately this seems to be an intentional design decision by Toyota and puts me and my passengers at risk.

Vehicle periodically fails to accelerate from a stop. Causing a 2-3 second delay in throttle response. This has been happening since new.